Complex BPQ32.cfg from N9LYA

N9LYA has setup a complex system using multi modes and multi ports. Using Packet 1k2 and 9k6, Hf Packet 300Baud, Robust packet, Winmor, Pactor, Fldigi, Axip, Telnet.

http://www.n9lya.com/

 

Remote Packet Station

I’m busy building a remote packet station.

  1. Airgrid AG-HP-5G23 For remote control the Pi 5Ghz Point to Point
  2. USB DC-DC step down module 4,5V-40V to 5 Volt 2A USB – Power for the Pi
  3. W1401 12V Digital Thermostat Temperature Controller Switch Module NTC Sensor
  4. Power supply Mean Well (150W, 12V,12.5A)
  5. 3x Fan 80x80x25 mm 12 volt
  6. Raspberry Pi 2
  7. 3D Sound card
  8. 2x Ground loop isolater
  9. Trx President Lincoln 2
  10. Antenna  Siro tornado 27 5/8
  11. 10Mtr EcoFlex 15

Connect the Pi to the Trx

DireWolf and Linpq with Systemd.

I have a bad time behind me, I have had a lot of arguments with Systemd to start DireWolf and Linpq when booting 🙂
If you like Systemd, you can read some about it here https://en.wikipedia.org/wiki/Systemd

I want Linbpq to run under /dev/tty2 and DireWolf under /dev/tty3. This is because if I login remotely I can view the monitor from DireWolf with “conspy”. “conspy 3” Hit esc a few times to leave conspy.

Systemd does not want to accept the start line with >/dev/tty3 &

This upper start line does not work.

So I had to come up with something else for that. So i wrote a start file. “direwolf.start”

Now i wrote a unit file to start DireWolf on boot.
/etc/systemd/system/direwolf.service

Now DireWolf is starting very nice on /dev/tty3

I had the same problem with Linbpq, which I solved in the same way.

Linbpq start file “runbpq”

The unit file “linbpq.service”

Ok, let’s see if it is running

Now have a look at /dev/tty2 “conspy 2”